Power Tiller The Necessary Fastening

power tiller The necessary fastening

After the work of the micro-tillage machine, it is necessary to carry out the necessary tightening and parts adjustment in time. After a certain period of time, the gap of some parts will increase, and the user should make the necessary adjustments.

Micro-farming machine manufacturers that part of the micro-farming machine clutch, reverse gear, throttle, steering and so are through the cable operation, and the cable is easy to deformation and elongation, so by adjusting the screw in time to adjust.

There are gears of the shaft of a shaft, two-axis, two pairs of conical gears and other use for some time, will have a certain gap, a shaft, two shafts through the tight back screw to adjust the two tapered gears by increasing the steel Gasket to adjust.

Micro-farming machine manufacturers to remind the use of the process, every day to carry out the necessary fastening. But to pay special attention to is that the engine screws do not easily tighten it, mainly those directly on the aluminum alloy shell screws. 1, micro-farming machine operators must go through professional training or familiar with the machine after the instructions can be operated, not familiar with the machine operating methods of personnel is strictly prohibited operation.

2, micro-farming machine operators should pay special attention to the safety warning signs on the machine, carefully read the contents of the logo, and express other operators.

3, micro-farming machine operators should pay attention to prevent the movement of parts caused by injury. To check whether all exposed rotary parts have been well protected.

4, micro-farming machine operators are strictly prohibited fatigue work, so as to avoid accidents.

5, micro-farming machine manufacturers to remind each time before the work must check the engine and gearbox oil is sufficient.

6, before use must check the parts and gearbox, the engine bolts are loose, off the phenomenon.

7, check the operating parts (bit) is flexible and effective.

8, the installation of a knife, you must confirm the left and right symmetry, working edge facing forward, or can not be used normally.

9, the engine must be checked before the start of the clutch in the separation position, whether the shift lever into the neutral position.

10, micro-farming machine manufacturers to ensure the normal work of the engine to extend its life, the engine must be empty after the start operation, hot car 5 to 10 minutes before work, start working 1 to 2 hours before the best not to high speed and weight Load work. If the engine starts when the phenomenon of speed, should be quickly cut off the oil supply or plug the engine to immediately turn off the engine.

11, the height of the resistance bar according to the work at any time to adjust to maintain the level of the fuselage to prevent excessive tilt due to the engine, resulting in poor engine lubrication and damage.

12, the operation process should be prohibited to touch all kinds of rotating knives, to avoid injury, and away from the exhaust pipe high temperature area, careful burns.

13, in the replacement of tools, removal of weeds and inspection and maintenance, must be stopped after the operation of the engine can be carried out.

14, is strictly prohibited in any way to improve the machine operating speed.